Wip Information - Samsung OfficeServ 7000 Series Programming Manual

CHAPTER 2. MMC Programming

[846] WIP INFORMATION

This MMC sets up the WiFi phone information.
No Parameter
00 REGISTERED
01 LOCATED
02 PHONE TYPE
05 IP OFFSET
06 IP ADDRESS
07 MAC ADDR
08 USER ID
09 PASSWORD
10 INSERT DGT
12 HO THRSH
13 HO DELTA
14 HO SCAN
2-406
Description
Shows if the terminal is registered.
Shows if the terminal is connected to the system.
If attached, wip phone's mode is also displayed (sip
mode or ospp mode)
Shows the type of the terminal.
Location of IP pool of the terminal IP
If AP type is not Commercial AP, this option can not
be shown.
Terminal IP address
Terminal MAC address
User ID per terminal
Password of terminal user
If five or more numbers are entered into the WIP
terminal, this INSERT DGT is prefixed to the
numbers, provided the entered numbers do not start
with a C.O. number, C.O. group number, LCR,
network LCR, or function code.
Handover Thresh Hold Value (-99~0)
Thresh Hold is a signal level which makes WLAN
phone start scanning for handover.
If this signal level is under the registered Thresh
Hold, WLAN phone will start scanning.
This parameter has a minus value but system only
displays the value without minus. (So the default
value of Thresh Hold will be shown as
70 not -70.)
Handover Delta Value (0~99)
DELTA means the signal level difference between AP
which includes WLAN phone and another AP. If this
signal level difference is over the registered DELTA,
WLAN phone will start to handover. In this case the
signal level of WLAN phone should be under the
Thresh Hold.
Handover Scan Time Value (0~99)
SCAN Time is a period of scanning for WLAN
Handover. If the signal level of WLAN phone is
under the Thresh Hold, WLAN phone will start
scanning with the registered period (=SCAN Time).
Default
NO
DETACH
NONE
-
0.0.0.0
0000 0000 0000
PHONE NUM
0000
-
70
05
01
© SAMSUNG Electronics Co., Ltd.