Samsung OfficeServ 7000 Series Programming Manual page 178

CHAPTER 2. MMC Programming
No Option
5 NB PLAN
UNKNOWN
ISDN
DATA
TELEX
NATIONAL
PRIVATE
EXTEN
6 CLIR w NUMB
8 ECT SERVICE
10 EFWD REROUT
12 NO CH BUSY
13 CD PLAN
14 CD TYPE
15 TIME SYNC
16 DIVERT
17 CENTREX
2-140
Used to select the type of the Calling Party Number Plan to send to the
network.
Unknown numbering plan
ISDN numbering plan (CCITT E.163-164)
Data numbering plan (CCITT X.121)
Telex numbering plan (CCITT F.69)
National standard numbering plan
Private numbering plan
Local numbering plan
In case of CLIR, the flag can be set to OFF and the CLI number can be
sent.
Specifies the ISDN explicit call transfer option as follows:
0. NONE
1. REQ
2. RCV
3. BOTH
(This option may not be available in certain OfficeServ system.)
If the option is set to ON, the rerouting message can be sent as
FACILITY type.
If BRI line is not available, this line can be set to be busy.
Specifies the called party's numbering plan as follows:
0. UNKNOWN
1. ISDN
2. NATION
Specifies the calling party's number type as follows:
0. UNKNOWN
1. INT. NAT
2. NATIONAL
3. NETWORK
4. SUBSCRIB
5. ABBREV
6. EXTEN
The time information of system can be updated automatically by BRI
incoming call.
In case of using MOBEX trunk, specifies partial rerouting message type
as follows:
0. OFF: Rerouting message can't be sent.
1. ON: Both diverting and original called number can be sent
2. EXCEPT CD: Only diverting number can be sent.
When ISDN trunk has centrex feature, MMC 210 ISDN PROGCON is
set to OFF and the 2nd progress message is incoming, dialed digit can
be sent as ISDN message type.
If the option is set to OFF, dialed digit is sent as DTMF type.
Description
© SAMSUNG Electronics Co., Ltd.
(Continued)