Mgi Parameters - Samsung OfficeServ 7000 Series Programming Manual

[831] MGI PARAMETERS

This MMC provides network configuration of the MGI/OAS card (s) in the system.
No Parameter
0 IP ADDRESS
1 GATEWAY
2 SUB MASK
3 IP TYPE
4 LOCAL RTP
5 CARD RESET
6 PUB IP1
7 PUB RTP1
8 PUB IP2
9 PUB RTP2
10 PUB IP3
11 PUB RTP3
12 QOS MONIT.
13 MAC ADDR
14 IP VERSION
If MP-MGI port (the embedded MGI) is selected, IP ADDRESS, GATEWAY, SUB
MASK, CARD RESET parameters can not be set in this MMC because these
parameters and the system values are the same. The system values can be
referred in MMC830
© SAMSUNG Electronics Co., Ltd.
OfficeServ 7000 Series Call Server Programming Manual
Specifies the IP address for the MGI card.
Specifies the designated IP gateway address used for contacting
IP devices beyond the local subnet.
Specifies the IP subnet mask. This parameter is used by the system to
calculate the range of IP devices (subnet) that are within 'direct reach'
of the MGI. (without having to go through the designated network IP
gateway)
Specifies if the system will be routing data over a public or private
network.
Specifies local rtp port The default value is 30000 and the value range
is between 10000 and 60000. If you use MPS function, the value must
be not duplicated with MMC861 MPS local rtp port.
This option is only shown in case of installed MGI 64/MGI16 card
Reboots MGI card.
Pulbic IP Address is only used for VoIP signaling protocols in a
NAT network . NAT system binds IP Address with Public IP and
processes a voice stream. See System IP Type on MMC 830.
Public RTP Port which NAT system binds a private RTP port with
Pulbic IP Address is only used for VoIP signaling protocols in a
NAT network . NAT system binds IP Address with Public IP and
processes a voice stream. See System IP Type on MMC 830.
Public RTP Port which NAT system binds a private RTP port with
Pulbic IP Address is only used for VoIP signaling protocols in a
NAT network . NAT system binds IP Address with Public IP and
processes a voice stream. See System IP Type on MMC 830.
Public RTP Port which NAT system binds a private RTP port with
Specifies use of QOS. This option is only shown in case of installed
MGI card. (not supportted MGI16/ 64)
Displays the MAC address of an MGI card
This option is only shown in case of installed MGI64/MGI16 card.
Specifies MGI IP version is Ipv4 / Ipv6. (This option may not be
available in certain OfficeServ models.)
Description
2-361