Samsung OfficeServ 7000 Series Programming Manual page 430

CHAPTER 2. MMC Programming
No Option
11 JITTER BUF
12 TOS/Difsrv
13 S/W VERSION
14 S/W UPGRADE
15 TIME ZONE
17 SIG TYPE
18 PRIVATE IP
19 VIDEO DSP
20 VIDEO SIZE
21 QoS ENABLE
22 FRC LOGOUT
2-392
Description
Decides the minimum time to consider delay for jitter
adjustment. This data uses MMC 841 ITP DSP
PARA DOWN = PHONE DATA only. The range is
10~90 ms.
An 8-bit binary value that will be used by external
routers, switches, etc, (that optionally support TOS-
bit prioritization) to identify the transport-priority
value of data packets generated by the IP phone.
This value can be left at the default value (00000)
if your network infrastructure does not support this
method of bandwidth management. This data uses
MMC 841 ITP DSP PARA DOWN = PHONE DATA
only.
Display IP phone software version. (Read only)
This is used as IP phone software upgrade request
command. When YES is selected and Right Soft
button is pressed, the system requests IP phone
software upgrade with TFTP IP address.
Allows remote IP phones to display own time zone.
This option can change UDP/TCP signal type for IP
phone. (ITP V3.xx only supports the TCP signal
type. If TCP is set and ITP V2.xx attempts to
connect, the TCP signal type will change from TCP
to UDP automatically.)
Displays private IP address of remote IP phone
allocated by phone's router.
Designate the standard video compression format of
the VIDEO IP phone. (H.263/MPEG4)
Designate the video input/output format of the codec
of the VIDEO IP phone. (CIF, QCIF)
Designate whether to use the QoS.
This is used to logout the registration of a particular
IP phone. IP phone should support IDLE MODE
function and be login status.
This is useful for maintenance.
(
Continued)
Default
20 ms
All bits 0
-
-
00.00
UDP
0.0.0.0
H.263
CIF
DISABLE
NO
© SAMSUNG Electronics Co., Ltd.