System Node Information - Samsung OfficeServ 7000 Series Programming Manual

[863] SYSTEM NODE INFORMATION

This MMC is the program that specifies the system information of SPNET (Samsung
Protocol Networking). It is useful when many systems are consisted through SPNET and
interlocked with LCR. There are maximum 2000 entries.
No
0 ACCESS NUM
1 IP ADDR
2 TEL NUMBER
3 MAX COUNT
4 NO MGI
SPNET is VoIP Network function developed by Samsung. (it is not standard
function.)
CONDITIONS
LINK ID should not be inputted at MMC 820 SYSTEM LINK and ACCESS NUMBER &
TEL NUMBER should be inputted at LCR table.
ACTION
1) Press Transfer button and enter 863.
Display shows:
2) Enter the node entry number.
OR
Press Volume button to select and press Right Soft
button to move cursor.
3) Enter the option number
OR
Press Volume button to select and press Right Soft
button to store.
4) Enter the access number.
© SAMSUNG Electronics Co., Ltd.
Option
Other System's ID
Other System's IP address
Rerouting Trunk Number (excluding VoIP Trunk Number).
If SPNET function is not work, Call is rerouted through this trunk
If you dial a valid digit string until Max Count number, the system
set up call.
No: Use MGI as of old, Yes: Don't use MGI
(This option can be shown in case that MMC 861 'MPS
SERVICE' set to ENABLE)
OfficeServ 7000 Series Call Server Programming Manual
Description
DISPLAY
(0001) ACCESS NUM
(0001) ACCESS NUM
(0001) ACCESS NUM
(0001) ACCESS NUM
1
2-435