Repacking the System Components
1
Remove the four screws (two on each side of
the chassis) that hold the bracket to the
chassis.
Remove the door stop from the right cable management frame by loosening and removing its two
g.
M4 screws (see
and put the two pieces and two screws in the small parts bag.
Figure E-7
1
Two parts to the right door stop
Pull off the two bushings from the post that the right door stop was attached to (see
h.
the bushings in the small parts bag.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
E-14
Appendix E
Figure
E-7). Pull the two pieces of the door stop off the cable management frame
Removing the Door Stop from the Right Cable Management Frame
2
Repacking the Cisco Nexus 7000 Series Switch for Shipment
2
Remove the four screws (two screws on each
side of the bracket) that hold the bracket to
each side frame.
Two M4 screws removed to disassemble the door stop.
Figure
E-8). Put
OL-23069-07