Cisco Nexus 7000 Hardware Installation And Reference Manual page 296

Installing an I/O Module
With a hand on each ejector, pull the module part way out of its slot in the chassis.
Step 7
Grasp the front edge of the module and place your other hand under the module to support its weight.
Step 8
Pull the module out of its slot. Do not touch the module circuitry.
To prevent ESD damage, avoid touching the electronic circuitry and prevent anything else from coming
Caution
in contact with the circuitry.
If you are removing the module from a Cisco Nexus 7010 chassis, rotate the module 90 degrees
Step 9
counterclockwise so that it is horizontal (with the circuitry seen from above).
Place the module on an antistatic mat or repack it in its original packing materials as shown in
Step 10
Figure 10-12
Figure 10-12
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
10-38
(8- and 48-port types of I/O modules) or
Repacking an 8- or 48-Port I/O Module (N7K-M108X2-12L, N7K-M148GT-11,
N7K-M148GT-11L, N7K-M148GS-11, or N7K-M148GS-11L)
Chapter 10 Installing or Replacing Components
Figure 10-13 (32-port types of I/O modules).
OL-23069-07