Cisco Nexus 7000 Hardware Installation And Reference Manual page 271

Chapter 10 Installing or Replacing Components
Figure 10-3
1
Coil the power cables and place them on the
bottom of the box.
2 Place the trifold cover over the coiled cables.
3 Put the power supply unit in its ESD bag and
hold the filler box outside the bag in the notched
portion of the power supply unit.
4
Place the nonexpanding end pad over the back
end of the power supply unit and filler box.
5 Pull the two sides of the expandable end pad
apart, fit the end pad over the front end of the
power supply unit, and press the two sides
together snuggly over the front end of the power
supply unit.
Either replace the power supply unit or cover the empty power supply bay as follows:
Step 10
• If you are ready to replace the power supply unit, see the
During Operations" section on page
OL-23069-07
Packing a DC Power Supply Unit
10-14.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Replacing a DC Power Supply Unit During Operations
6
Place the padded power supply unit inside the
box and on top of the trifold.
7 Fold the narrow flaps over the power supply
unit pads.
8 Fold the wide flaps over the power supply
unit.
9
Tape the wide flaps together and to the box
with packing tape.
"Installing a 6-kW DC Power Supply Unit
10-13