Replacing the Cable Management Frame on the Cisco Nexus 7018 Chassis
Figure 10-31
1
Rack-mount bracket.
2
Upper cable management assembly. 4
Repeat Step 3 to attach an upper cable management assembly to the upper right side of the chassis. When
Step 5
completed, the chassis will appear as shown in
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
10-78
Attaching an Upper Cable Management Assembly to a Rack-Mount Bracket
3
Chapter 10
Position the assembly so that the two upper hooks on the
rack-mount bracket fit inside the two holes on the
assembly, and then slide the assembly down so that it is
held by the hooks.
Loosely fasten the assembly to the rack-mount bracket
with four M4x10 screws. Do not tighten these screws.
Figure
10-32.
Installing or Replacing Components
OL-23069-07