Cisco Nexus 7000 Hardware Installation And Reference Manual page 284

Replacing a Supervisor Module
This setup utility will guide you through the basic configuration of
the system. Setup configures only enough connectivity for management
of the system.
Please register Cisco Nexus7000 Family devices promptly with your
supplier. Failure to register may affect response times for initial
service calls. Nexus7000 devices must be registered to receive
entitled support services.
Press Enter at anytime to skip a dialog. Use ctrl-c at anytime
to skip the remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no): no
When asked to log in, enter the login and password that you specified in step 12.
Step 15
User Access Verification
switch login:
Password:
Verify that the switch is running the required version of the NX-OS software by using the show version
Step 16
command.
switch(config)# show version
If the version of NX-OS is not the same as you intended to use, copy the previously saved images from
Note
the USB drive in SLOT 0 to bootflash: and perform an upgrade to the appropriate version. For more
information, see the Cisco Nexus 7000 Series NX-OS Software Upgrade and Downgrade Guide.
Step 17 Copy the TAR archive containing the license files from the USB SLOT 0 drive to bootflash:, extract the
archive, and install the licenses by using the copy, tar extract, and install license commands. Repeat
the install license command for each extracted license file.
switch(config)# copy slot0:
switch(config)# tar extract bootflash:
switch(config)# install license bootflash:
Note The tar extract command requires that the TAR file be located in bootflash: or volatile:.
Step 18 Make sure that all I/O modules are online and that the standby supervisor is in ha-standby mode by using
the show module command.
switch(config)# show module
Mod
---
2
6
7
...
If there are Fabric 2 modules in the switch, upgrade the Fabric 2 EPLDs (see the
Step 19
section on page
Restore the previously saved configurations by using the copy command to copy the configuration file
Step 20
in the USB drive to the running configuration.
switch(config)# copy slot0:
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
10-26
licenses_archive_file_name
Ports Module-Type
----- ----------------------------------- ------------------ ---------------
0 Supervisor module-2
0 Supervisor module-2
48 1/10 Gbps Ethernet Module
8-34).
configuration_file_name
Chapter 10
.tar bootflash:
licenses_archive_file_name
license_file_name
.lic
Model
N7K-SUP2E
N7K-SUP2E
N7K-F248XP-25
running-config
Installing or Replacing Components
.tar to bootflash:
Status
active *
ha-standby
ok
"Configuring EPLDs"
OL-23069-07