Installing The Chassis; Prerequisites For Installing The Chassis - Cisco Nexus 7000 Hardware Installation And Reference Manual

Chapter 4 Installing a Cisco Nexus 7010 Chassis
Figure 4-2
1

Installing the Chassis

This section describes how to install the Cisco Nexus 7010 chassis in a rack or cabinet. These installation
steps include transporting the chassis, elevating the chassis to the rack using a mechanical lift, pushing
the chassis onto the rack, and then securing the chassis to the rack.
This section includes the following topics:
•
•
•

Prerequisites for Installing the Chassis

Before you install the chassis, you must make sure that the following items are available for the
installation:
•
•
OL-23069-07
Attaching a Bottom-Support Rail to a Rack
Four sets of 3 M6 x 19 mm Phillips screws or
four sets of 3 12-24 x 3/4 in. Phillips screws
Prerequisites for Installing the Chassis, page 4-7
Required Tools and Equipment, page 4-8
Installing the Chassis, page 4-9
Data center ground is accessible where you are installing the Cisco Nexus 7010 chassis.
Four-post, 19-inch EIA rack or cabinet that includes such a rack.
For more information on the rack or cabinet, see the
on page 4-2.
2
Adjustable bottom-support rails (2)
"Installing a Four-Post Rack or Cabinet" section
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Installing the Chassis
4-7