Cisco Nexus 7000 Hardware Installation And Reference Manual page 295

Chapter 10 Installing or Replacing Components
Note
Invisible laser radiation may be omitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
Loosen the two captive screws identified in View A of
Step 4
Figure 10-11
1
Unscrew two captive screws.
2
Simultaneously press both ejector buttons.
Press ejector release buttons on the top and bottom ends of the module (see View B in
Step 5
push out the ejector levers and to disconnect the module.
Simultaneously rotate the two ejector levers outward to unseat the module from the midplane connector
Step 6
(see View C in
OL-23069-07
To prevent contaminants from entering the fiber-optic lines or transceivers, cover the fiber-optic
openings with a plug.
Unseating an I/O Module
Figure 10-11).
Figure
3
Simultaneously swing open both ejector
levers to unseat the module.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Installing an I/O Module
10-11.
Figure 10-11) to
10-37