I/O Module Leds - Cisco Nexus 7000 Hardware Installation And Reference Manual

I/O Module LEDs

I/O Module LEDs

Table D-3
Table D-3 I/O Module LEDs
LED
ID
Status
Link (for each port)
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
D-4
describes the I/O module LEDs.
Status Description
Flashing blue The operator has activated this LED to identify this module in the chassis.
Off This module is not being identified.
Green All diagnostics pass. The module is operational (normal initialization
sequence).
Red The module has detected a slot ID parity error and will not power on or boot up.
or
The module is not fully inserted, and it is not making a reliable connection with
the supervisor.
or
The module has failed diagnostic tests and has powered down.
Flashing red The switch has just been powered on, and the module is resetting.
or
The module is resetting and both ejector levers are out.
or
The module has been inserted during the initialization process.
or
The module could not power up because of insufficient power.
or
An overtemperature condition has occurred. A major temperature threshold has
been exceeded during environmental monitoring.
Off The module is not receiving power.
Green The port is active (the link is connected and active).
Orange The port is disabled by the operator or is not initializing.
Flashing orange The port is faulty and disabled.
Off The port is not active or the link is not connected.
Appendix D Chassis and Module LEDs
OL-23069-07