Cisco Nexus 7000 Hardware Installation And Reference Manual page 326

Replacing the Front Doors and Frame Assembly on the Cisco Nexus 7010 Chassis
1 Bottom frame assembly with screw holes
aligned to screw holes in chassis.
Step 2 For each of the two front doors, match the two alignment pins on the door frame to the alignment holes
on the chassis. Position each door frame immediately under the cable management area (see
Figure
Figure 10-23
1 Front door frames.
2 Cable management area.
Step 3 Tighten three captive screws for each door frame (see
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
10-68
10-23).
Installing the Front Doors
Chapter 10 Installing or Replacing Components
2 Tighten four M4 x 6 mm screws.
3 Place each door frame on front edge of chassis
and immediately under the cable management
area.
Figure 10-24).
OL-23069-07