Repacking The Cisco Nexus 7009 Switch - Cisco Nexus 7000 Hardware Installation And Reference Manual

Repacking the System Components
Place one of the foam pads (Callout 3 in
Step 13
Move the chassis from the rack and to its pallet in one of the following ways:
Step 14
•
•
•
If the chassis is on a mechanical lift, place the lift next to the pallet, position the bottom of the chassis
Step 15
no more than 0.25 inches [0.64 cm] above the top of the padding on the pallet, and use two persons to
push or lift the chassis onto the padding. Make sure that the rear of the chassis is placed against one of
the padding walls (that leaves an open area in the padding in front of the chassis).
If you removed the power supplies before moving the chassis, replace each power supply in the chassis
Step 16
as follows:
a.
b.
c.
d.
Place the cardboard insert in the remaining open area in the padding and in front of the chassis (see
Step 17
Callout 5 in
Step 18 Place the foam padding on top of the chassis (see Callout 6 in
Step 19 Place the four-sided box around the chassis and the top pallet. (see Callout 7 in
Place the accessory tray inside the four-sided box and on top of the padding (see Callout 8 in
Step 20
Place the accessory kit and the front door kit in the accessory tray (see Callout 9 in
Step 21
Place the cardboard top on the chassis box (see callout 10 in
Step 22
Place four edge protectors (Callout 11 in
Step 23
will be placing the packing straps.
Fasten the top of the box to the box and pallet with two packing straps (see Callout 12 in
Step 24

Repacking the Cisco Nexus 7009 Switch

Before you remove a Cisco Nexus 7009 switch chassis from a rack, lay its two pallets (two pallets bolted
together) on the floor and set its packing materials nearby. If you do not have the original packing
materials, order another set of these materials (part number N7K-C7009-SHPPKG=).
Do not subject the pallet, switch, or package to water or moisture.
Caution
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
E-8
If the chassis is sitting on a mechanical lift, use the mechanical lift to move the chassis from the rack
to the pallet.
If the chassis is sitting on top of another chassis, use two people to push the chassis all the way onto
the mechanical lift placed in front of the chassis, and then use the mechanical lift to move the chassis
to the pallet.
If you are using two or more people to lift the chassis, lift the chassis out of the rack and move it to
the pallet.
Have two people tilt the front of the chassis up about 2 inches (5 cm).
Holding the bottom of the power supply with one hand and its front handle with the other hand, align
the power supply to an open power supply bay and push the power supply fully into the slot until its
latch clicks.
Repeat steps 17b for each power supply that you need to put back in the chassis.
Place the chassis back down on the padding.
Figure E-3).
Appendix E Repacking the Cisco Nexus 7000 Series Switch for Shipment
Figure E-3) inside the box bottom.
Figure
Figure
Figure E-3) along the top edges of the cardboard top where you
E-3).
Figure E-3).
Figure
Figure E-3).
E-3).
Figure
OL-23069-07
E-3).
E-3).