Checking The State Of A Module - Cisco Nexus 7000 Hardware Installation And Reference Manual

Appendix 8 Managing the Switch Hardware
Mod
---
2
3
4
5
6
7
9
Mod
---
2
3
4
5
6
7
9
Mod
---
2
3
4
5
6
7
9
...
switch#
The Status column in the output should display an ok status for switching modules and an active or
standby (or HA-standby) status for supervisor modules. If the status is either ok or active, you can
continue with your configuration.
A standby supervisor module reflects the HA-standby status if the HA switchover mechanism is enabled.
Note
If the warm switchover mechanism is enabled, the standby supervisor module reflects the standby status.
For information about the states through which a switching module progresses, see the
State of a Module" section on page

Checking the State of a Module

If your chassis has more than one I/O module, you can check the progress by repeatedly using the show
module command and viewing the Status column each time.
The I/O module goes through a testing and an initializing stage before displaying an ok status.
describes the possible states in which a module can exist.
OL-23069-06
Sw Hw
-------------- ------
5.0(2) 1.3
5.0(2) 1.3
5.0(2) 1.3
5.0(2) 1.2
5.0(2) 1.2
5.0(2) 1.5
5.0(2) 1.2
MAC-Address(es)
--------------------------------------
00-24-98-e9-14-58 to 00-24-98-e9-14-8c
00-24-98-e8-28-84 to 00-24-98-e8-28-b8
00-24-f7-1c-85-b0 to 00-24-f7-1c-85-e4
00-24-98-6f-95-00 to 00-24-98-6f-95-08
00-24-f7-18-92-88 to 00-24-f7-18-92-90
00-24-98-e9-29-60 to 00-24-98-e9-29-84
00-24-f7-1c-d5-50 to 00-24-f7-1c-d5-84
Online Diag Status
------------------
Pass
Pass
Pass
Pass
Pass
Pass
Pass
Serial-Num
----------
JAF1306AAFP
JAF1303ACPB
JAF1309ABLE
JAF1309AECN
JAF1309AEFE
JAF1307ALCB
JAF1311AEMM
8-19.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Checking the State of a Module
"Checking the
Table 8-6
8-19