Cisco Nexus 7000 Hardware Installation And Reference Manual page 292

Replacing a Supervisor Module
Grasp the front edge of the module with one hand and place your other hand under the lower side of the
Step 7
module to support its weight. Pull the module out of its slot.
To prevent ESD damage, avoid touching the electronic circuitry and prevent anything else from coming
Caution
in contact with its circuitry.
If you are removing the module from a Cisco 7010 chassis, rotate the module 90 degrees
Step 8
counterclockwise so that it is horizontal and you can see the circuitry from above.
For the DIMM in the second memory slot from the front of the supervisor module, rotate the two spring
Step 9
clips away from the DIMM (see Callout 1 in
Figure 10-10
1 On the second socket from the front of the
module, rotate both spring clips away from
the DIMM.
2 Hold the DIMM by its edges and pull it out of
the memory slot.
Holding the edges of the 4-GB DIMM with your fingers, slide it out of its memory slot (see Callout 2 in
Step 10
Figure
Remove the 8-GB label from the front of the module.
Step 11
Rotate both ejector levers away from the front of the supervisor module.
Step 12
Grasp the front of the module with one hand and place your other hand under the module to support its
Step 13
weight.
Align the module to the open supervisor slot in the chassis and push the module into the slot until it
Step 14
makes contact with the midplane.
Simultaneously push both ejector levers inward until they come in contact with the face of the module.
Step 15
The module should be fully seated in the slot and the captive screws should be aligned with their holes
Step 16
in the chassis. The EMI gasket should close the gap between this module and the next module.
Screw in the two captive screws to the chassis and tighten them to 8 in-lb (0.9 N·m).
Step 17
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
10-34
Removing a 4-GB DIMM
10-10) and place it in an antistatic bag.
Chapter 10
Figure 10-10).
3 Remove the "8 GB" label on the front of the
module.
Installing or Replacing Components
OL-23069-07