Replacing the Front Door and Air Intake Assemblies on the Cisco Nexus 7018 Chassis
This section includes the following topics:
•
•
Removing the Front Door and Air Intake Assemblies
When you remove the front door and air intake assemblies, you remove the door, air intake assembly,
and the hardware used to hold those components to the chassis.
To remove the front door and air intake assemblies on the Cisco Nexus 7018 chassis, follow these steps:
Remove the front door by following these steps:
Step 1
a.
Figure 10-35
1
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
10-82
Removing the Front Door and Air Intake Assemblies, page 10-82
Cleaning or Replacing the Air Filter for the Cisco Nexus 7010 Chassis, page 10-100
Open the door by pulling one of its latch handles out until it clicks (the handle clicks when you pull
it out about 30 degrees) and rotating the door away from the chassis (see Callouts 1 and 2 in
Figure
10-35).
Opening the Front Door
Open one of the two latch handles until it clicks.
Chapter 10
Installing or Replacing Components
2
Swing open the door.
OL-23069-07