C H A P T E R 7 Connecting The Cisco Nexus 7000 Series Switch To The Network; Connecting To The Console - Cisco Nexus 7000 Hardware Installation And Reference Manual

Connecting to the Console

•

Connecting to the Console

Before you create a network management connection for a Cisco Nexus 7000 Series switch or connect
the switch to the network, you must create a local management connection through a console terminal
and configure an IP address for the switch.
You can also use the console to perform the following functions, each of which can be performed through
the management interface after you make that connection later on:
•
•
•
•
This local management connection is made between the asynchronous serial port on each Cisco Nexus
7000 Series supervisor module and a console device capable of asynchronous transmission, such as a
computer terminal. On the supervisor modules, you use one of the following two asynchronous serial
ports:
•
•
Note Before you can connect the console port to a computer terminal, make sure that the computer terminal
supports VT100 terminal emulation. The terminal emulation software makes communication between
the switch and computer possible during setup and configuration.
To connect the Cisco Nexus 7000 Series switch to a computer terminal, follow these steps for each
supervisor module installed:
Step 1 Configure the terminal to match the following default port characteristics:
•
•
•
•
Connect an RJ-45 rollover cable to one of the following serial ports on one of the supervisor modules on
Step 2
the Cisco Nexus 7000 Series switch:
•
•
You can find this cable in the console cable connector kit, which is part of the accessory kit for the Cisco
Nexus 7000 Series switch.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
7-2
If you are creating a management connection to the supervisor module, you need to use a modular,
RJ-45, UTP straight-through or crossover cable.
Configure the switch using the command-line interface (CLI).
Monitor network statistics and errors.
Configure Simple Network Management Protocol (SNMP) agent parameters.
Download software updates.
CONSOLE SERIAL PORT
This port is used for direct connections to the console.
COM1/AUX SERIAL PORT (Supervisor 1 only)
This port is used for modem connections to the console.
9600 baud
8 data bits
1 stop bit
No parity
CONSOLE SERIAL PORT—Use this port if you are not using a modem.
COM1/AUX SERIAL PORT—Use this port if you are using a modem (available with only
Supervisor 1).
Chapter 7 Connecting the Cisco Nexus 7000 Series Switch to the Network
OL-23069-07