Cisco Nexus 7000 Hardware Installation And Reference Manual page 140

Installing the Cable Management Frame
Attach an upper cable management assembly (800-31342-01) onto the two hooks that protrude from the
Step 3
upper half of the left rack-mount bracket that is attached to the Cisco Nexus 7018 switch chassis, and
loosely fasten the assembly to the chassis with four flat-head M4x10 screws as shown in
Figure 5-9
1
Rack-mount bracket.
2 Upper cable management assembly. 4
Step 4 Repeat Step 3 to attach an upper cable management assembly to the upper right side of the chassis. When
completed, the chassis will appear as shown in
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
5-18
Attaching a Left Cable Management Assembly to a Rack-Mount Bracket
3
Chapter 5 Installing a Cisco Nexus 7018 Chassis
Position the assembly so that the two upper hooks on
the rack-mount bracket fit inside the two holes on the
assembly, and then slide the assembly down so that it is
held by the hooks.
Loosely fasten the assembly to the rack-mount bracket
with four M4x10 screws. Do not tighten these screws.
Figure 5-10.
Figure 5-9.
OL-23069-07