Configuring Virtual Terminal Line Settings - Cisco 4700M Administration Manual

Setting Up the ACE
Command
terminal no width
Example:
host1/Admin# terminal no width
Step 6
show terminal
Example:
host1/Admin# show terminal
TTY: /dev/pts/0 Type: "vt100"
Length: 25 lines, Width: 80 columns
Session Timeout: 60 minutes

Configuring Virtual Terminal Line Settings

This section describes how to configure the virtual terminal line settings to enable remote access to the
ACE. A virtual terminal line is not associated with the console port; instead, it is a virtual port that allows
you to access the ACE.
Detailed Steps
Command
Step 1
config
Example:
host1/Admin# config
host1/Admin(config)#
Step 2
line vty
Example:
host1/Admin(config)# line vty
host1/Admin(config-line)#
Step 3
session-limit number
Example:
host1/Admin(config-line)# session-limit 23
no session-limit number
Example:
host1/Admin(config-line)# no session-limit
23
Step 4
do copy running-config startup-config
Example:
host1/Admin(config-line)# do copy
running-config startup-config
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-26
Purpose
(Optional) Resets a terminal setting to its default value.
(Optional) Displays the console terminal settings.
Purpose
Enters global configuration mode.
Enters line configuration mode.
Specifies the maximum number of terminal sessions per line. The
range is from 1 to 251.
(Optional) Disables a setting for the configured virtual terminal
line.
(Optional) Copies the running configuration to the startup
configuration.
Chapter 1 Setting Up the ACE
OL-20823-01