Cisco 4700M Administration Manual page 263

Chapter 8 Configuring the XML Interface
<interface_standby>
<ipaddress>not set</ipaddress>
</interface_standby>
<interface_sup_enabled>Assigned</interface_sup_enabled>
<interface_auto_status>up</interface_auto_status>
</xml_interface>
<interface_stats>
<ifs_input>
<ifs_unicast>50</ifs_unicast>
<ifs_bytes>8963</ifs_bytes>
<ifs_multicast>26</ifs_multicast>
<ifs_broadcast>1</ifs_broadcast>
<ifs_errors>0</ifs_errors>
<ifs_unknown>0</ifs_unknown>
<ifs_ignored>0</ifs_ignored>
<ifs_unicast_rpf>0</ifs_unicast_rpf>
</ifs_input>
<ifs_output>
<ifs_unicast>45</ifs_unicast>
<ifs_bytes>5723</ifs_bytes>
<ifs_multicast>0</ifs_multicast>
<ifs_broadcast>1</ifs_broadcast>
<ifs_errors>0</ifs_errors>
<ifs_ignored>0</ifs_ignored>
</ifs_output>
</interface_stats>
</xml_interface_entry>
</xml_show_interface>
</xml_show_result>
</exec_command>
</response_xml>
Details
Command
xml-show {off | on | status}
Example:
host1/Admin# xml-show on
OL-20823-01
Purpose
Enables the display of raw XML request show command
output in XML format.
The keywords are as follows:
off—Displays CLI show command output in regular CLI
•
display output, not in XML format.
on—Displays CLI show command output in XML format
•
unless a specific show command is not implemented to
display its output in XML format. F or details on the show
command output supported in XML format, consult the
the ACE DTD file, ace_appliance.dtd, that is included as
part of the software image (see the
DTD File"
status—Displays the results of the xml show command
•
status: on or off. The status keyword allows you to
determine the status of the xml show command setting.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Configuring the XML Interface
"Accessing the ACE
section).
8-17