Cisco 4700M Administration Manual page 23

Chapter 1 Setting Up the ACE
At the prompt "Enter the management port IP Address (n.n.n.n): [192.168.1.10]:", assign an IP address
Step 8
to the management VLAN interface. When you assign an IP address to a VLAN interface, the ACE
automatically makes it a routed mode interface. Press Enter.
At the prompt "Enter the management port Netmask(n.n.n.n): [255.255.255.0]:", assign a subnet mask
Step 9
to the management VLAN interface. Press Enter.
At the prompt "Enter the default route next hop IP Address (n.n.n.n) or <enter> to ski p this step:", choose
Step 10
whether to assign an IP address of the gateway router (the next-hop address for this route). If you specify
yes, enter the IP address of default gateway. The gateway address must be in the same network as
specified in the IP address for a VLAN interface. Press Enter.
After you configure the Ethernet port, the setup script displays a summary of entered values:
Step 11
Management Port: 3
Ip address 12.3.4.5
Netmask: 255.255.255.0
Default Route: 23.4.5.6
At the prompt "Submit the configuration including security settings to the ACE Appliance?
Step 12
(yes/no/details): [y]:", enter one of the following replies:
Type y to apply the appropriate configuration and save the running-configuration to the
•
startup-configuration file. This is the default.
Type n to bypass applying the configuration and saving the running-configuration to the
•
startup-configuration file.
Type d to view a detailed summary of the entered configuration values before you apply those
•
configuration values to the ACE.
If you select d, the configuration summary appears:
Step 13
interface gigabitEthernet 1/3
switchport access vlan 1000
no shut
access-list ALL extended permit ip any any class-map type management match-any
remote_access
match protocol xml-https any
match protocol dm-telnet any
match protocol icmp any
match protocol telnet any
match protocol ssh any
match protocol http any
match protocol https any
match protocol snmp any
policy-map type management first-match remote_mgmt_allow_policy
class remote_access
permit
interface vlan 1000
ip address 192.168.1.10 255.255.255.0
access-group input ALL
service-policy input remote_mgmt_allow_policy
no shutdown
ssh key rsa
ip route 0.0.0.0 0.0.0.0 172.16.2.1
The prompt "Submit the configuration including security settings to the ACE Appliance?
(yes/no/details): [y]:" reappears. Enter one of the following replies:
Type y to apply the appropriate configuration and save the running-configuration to the
•
startup-configuration file. This is the default.
OL-20823-01
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Setting Up the ACE
1-7