Default Settings For Snmp - Cisco 4700M Administration Manual

Default Settings for SNMP

Table 7-4 SNMP Trap Support (continued)
Notification Name
cslbxServerFarmStateChange
coldStart
linkUp, linkDown
Default Settings for SNMP
Table 7-5
Table 7-5 Default SNMP Parameters
Parameter
SNMP notifications
Implementation of linkUp and linkDown traps
SNMP engine ID for the Admin context and each
user context
snmpCommunityName and
snmpCommunitySecurityName OIDs of the
SNMP-COMMUNITY-MIB
Cisco 4700 Series Application Control Engine Appliance Administration Guide
7-30
Location of the
Notification
CISCO-SLB-EXT-MIB Notification that all real servers in a server farm are down and
SNMPv2-MIB
SNMPv2-MIB
lists the default settings for the SNMP parameters.
Default
None defined or issued.
Cisco implementation of linkUp and linkDown traps to NMS is enabled
(not the Internet Engineering Task Force (IETF) standards-based
implementation).
The ACE automatically creates the engine ID.
These OIDs are masked by default.
Description
the server farm has changed state. The varbind contains the
following details:
cslbxServerFarmName
•
cslbxServerFarmState
•
cslbxServerFarmStateChangeDescr
•
cslbxServerFarmNumOfTimeFailOvers
•
cslbxServerFarmNumOfTimeBkInServs
•
SNMP agent started after a cold restart (full power cycle) of the
ACE.
VLAN interface is up or do wn. A VLAN interface can be down,
for example, if you specified the shut command followed by the
no shut command, or the VLAN was removed from the switch
configuration.
The Ethernet data port, Ethernet management port, and
Note
port-channel interfaces are available only in Admin
context. In this case, the linkUp and link Down
notifications support all the interfaces for Admin
contexts, while each individual user context supports
only VLAN and BVI interfaces.
Chapter 7 Configuring SNMP
OL-20823-01