Cisco 4700M Administration Manual page 41

Chapter 1 Setting Up the ACE
Detailed Steps
Command
Step 1
terminal length lines
Example:
host1/Admin# terminal lines 50
Step 2
terminal monitor
Example:
host1/Admin# terminal monitor
%ACE-7-111009: User 'admin'
executed cmd: terminal monitor
%ACE-7-111009: User 'admin'
executed cmd: terminal
monitor......
terminal no monitor
Example:
host1/Admin# terminal no monitor
Step 3
terminal session-timeout minutes
Example:
host1/Admin# terminal
session-timeout 600
Step 4
terminal terminal-type text
Example:
host1/Admin# terminal terminal-type
vt200
Step 5
terminal width characters
Example:
host1/Admin# terminal width 250
OL-20823-01
Purpose
Specifies the number of lines for displaying information on a terminal
during a console session.
The lines argument sets the number of lines displayed on the current
terminal screen. This command is specific to only the console port. Telnet
and SSH sessions set the length automatically. Valid entries are from 0 to
511. The default is 24 lines. A value of 0 instructs the ACE to scroll
continuously (no pausing) and overrides the terminal width value. If you
later change the terminal length to any other value, the originally
configured terminal width value takes effect.
Starts the terminal monitor session and displays syslog output on the
terminal. To enable the various levels of syslog messages to the terminal,
use the logging monitor command (see the Cisco 4700 Series
Application Control Engine Appliance System Message Guide for
details).
(Optional) Stops the current terminal monitoring session.
Specifies the inactivity timeout value in minutes to configure the
automatic logout time for the current terminal session on the ACE. When
inactivity exceeds the time limit configured by this command, the ACE
closes the session and exits. The range is from 0 to 525600. The default
value is inherited from the value that is configured for the login timeout
command. If you do not configure a value for the login timeout
command, the default for both commands is 5 minutes. You can set the
terminal session-timeout value to 0 to disable this feature so that the
terminal remains active until you choose to exit the ACE. The ACE does
not save this change in the configuration file.
The minutes argument sets the timeout value in minutes.
Specifies the name and type of the terminal used to access the ACE. If a
Telnet or SSH session specifies an unknown terminal type, the ACE uses
the VT100 terminal by default.
The minutes argument is the terminal type. Specify a text string from 1 to
80 alphanumeric characters.
Specifies the width for displaying information on a terminal during a
console session. This command is specific to the console port only.Telnet
and SSH sessions set the width automatically.
The characters argument sets the number of characters displayed on the
current terminal screen. Valid entries are from 24 to 512
80 columns.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Setting Up the ACE
The default is
.
1-25