Cisco 4700M Administration Manual page 181

Chapter 6 Configuring Redundant ACEs
Command
show ft track {detail | status |
summary}
Table 6-6
Table 6-6 Field Descriptions for the show ft track Command Output
Field Description
FT Group FT group identifier.
Status Configured state of the FT group. Possible states are the in-service or out-of-service state.
Maintenance Mode Current maintenance mode of the local co ntext in an FT group. Applications can turn on maintenance
mode when there is an inability to communicate with the peer, license mismatches, too many
application errors, and so on. Possible states are:
•
•
•
OL-20823-01
Purpose
Displays tracking information.
The keywords are:
detail—Displays detailed tracking information
•
status—Displays the current operating status of the peer plus additional
•
information
summary—Displays summary peer information
•
describes the fields in the show ft track command output.
MAINT_MODE_OFF—Maintenance mode is turned off.
MAINT_MODE_PARTIAL— All standby contexts transition to the
FSM_FT_STATE_STANDBY_COLD state (see the "My State" field description). The ACE
enters this mode if configuration synchronization fails.
MAINT_MODE_FULL—All contexts on the ACE become nonredundant causing their peer
contexts to become active. The ACE enters this mode just before you reboot the appliance and
is used primarily when you upgrade the ACE software.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Displaying or Clearing Redundancy Information
6-37