Displaying Or Clearing Redundancy Information - Cisco 4700M Administration Manual

Chapter 6 Configuring Redundant ACEs
Command
no peer track-interface vlan vlan_id
Example:
host1/Admin(config-ft-track-intf)# no peer
track-interface vlan 200
Step 7
peer priority number
Example:
host1/Admin(config-ft-track-intf)# peer
priority 25
no peer priority number
Example:
host1/Admin(config-ft-track-intf)# no peer
priority 25
Step 8
do copy running-config startup-config
Example:
host1/Admin(config-ft-track-intf)# do copy
running-config startup-config
Examples
The following example demonstrates a tracking configuration for an interface on the active member of
an FT group and configures the interface that you want the standby member to track:
ft track interface TRACK_VLAN100
track-interface vlan 100
priority 50
peer track-interface vlan 200
peer priority 25
In this configuration example, if VLAN 100 goes down, then the ACE reduces the priority of the FT
group on the active member by 50. If at any time the priority of the FT group on the active member falls
below the priority of the FT group on the standby member, a switchover occurs.

Displaying or Clearing Redundancy Information

This section describes how to display or clear information about redundancy and contains the following
sections:
•
•
OL-20823-01
Displaying Redundancy Information
Clearing Redundancy Statistics
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Displaying or Clearing Redundancy Information
Purpose
(Optional) Removes the VLAN from the tracking process.
Assigns a priority to the tracked interface that the standby
member is tracking.
The number argument specifies the priority of the interface on the
standby member. Enter a priority value as an integer from 0 to
255. The default is 0. Higher values indicate higher priorities.
Assign a priority value based on the relative importance of the
interface that you are tracking.
(Optional) Resets the interface priority on the standby member to
the default value of 0.
(Optional) Copies the running configuration to the startup
configuration.
6-27