Configuring Snmp Notifications; Configuring Snmp Notification Hosts - Cisco 4700M Administration Manual

Configuring SNMP
Command
no snmp-server location
Example:
host1/Admin(config)# no snmp-server
location
Step 3
do copy running-config startup-config
Example:
host1/Admin(config)# do copy
running-config startup-config

Configuring SNMP Notifications

This section describes how to configure the ACE to send traps or inform requests as notifications to an
SNMP manager when a particular event occurs. In some instances, traps are unreliable because the
receiver does not send any acknowledgment when it receives a trap. The sender cannot determine if the
trap was received. However, an SNMP manager that receives inform requests acknowledges the message
with an SNMP Response PDU. If the sender never receives a Response, the inform request is normally
retransmitted. Inform requests are more likely to reach their intended destination.
Use the SNMP-TARGET-MIB to obtain more information on the destinations to which notifications are
to be sent either as traps or as SNMP inform requests. See the
section for details.
This section contains the following topics:
•
•
•

Configuring SNMP Notification Hosts

This section describes how to specify which host receives SNMP notifications.
Restrictions
This topic includes the following restrictions:
•
•
Cisco 4700 Series Application Control Engine Appliance Administration Guide
7-38
Configuring SNMP Notification Hosts
Enabling SNMP Notifications
Enabling the IETF Standard for SNMP linkUp and linkDown Traps
To send notifications, you must specify at least one host to receive SNMP notifications.
The ACE supports a maximum of 10 SNMP hosts per context.
Purpose
Removes the SNMP system location information.
(Optional) Copies the running configuration to the startup
configuration.
"Supported MIBs and Notifications"
Chapter 7 Configuring SNMP
OL-20823-01