Cisco 4700M Administration Manual page 60

Enabling Remote Access to the ACE
Detailed Steps
Command
Step 1
config
Example:
host1/Admin# config
host1/Admin(config)#
Step 2
class-map type management [match-all |
match-any] map_name
Example:
host1/Admin(config)# class-map type
management match-all
SSH-TELNET_ALLOW_CLASS
host1/Admin(config-cmap-mgmt)#
no class-map type management [match-all |
match-any] map_name
Example:
host1/Admin(config)# no class-map type
management match-all
SSH-TELNET_ALLOW_CLASS
Cisco 4700 Series Application Control Engine Appliance Administration Guide
2-6
Chapter 2
Purpose
Enters global configuration mode.
Create a Layer 3 and Layer 4 class map to classify the remote
network management traffic received by the ACE.
The keywords, arguments, and options are as follows:
match-all | match-any—(Optional) Determines how the
•
ACE evaluates Layer 3 and Layer 4 network management
traffic when multiple match criteria exist in a class map. The
class map is considered a match if the match commands
meet one of the following conditions:
match-all —(Default) All of the match criteria listed in
–
the class map are satisfied to match the network traffic
class in the class map, t y pically match commands of the
same type.
match-any—Any one of the match criteria listed in the
–
class map is satisfied to match the network traffic class
in the class map, typically match commands of different
types.
map_name—Specifies the name assigned to the class map.
•
Enter an unquoted text string with no spaces and a maximum
of 64 alphanumeric characters.
The CLI enters the class map management configuration mode.
(Optional) Remove a Layer 3 and Layer 4 network management
class map from the ACE.
Enabling Remote Access to the ACE
OL-20823-01