Displaying or Clearing Redundancy Information
Displaying Redundancy Information
This section describes the show commands that display configuration, status, and statistical information
for your redundancy configuration and contains the following sections:
•
•
•
•
•
•
•
•
•
Displaying Redundancy Configuration Information
To display the list of redundancy or fault-tolerance (FT) configurations configured for the current
context, perform the following task:
Command
show running-config ft
Displaying Bulk Synchronization Command Failures on the Standby ACE
To display the configuration commands that fail on the standby ACE appliance during bulk
synchronization in a redundant configuration per context, perform the following task:
Command
show ft config-error [context_name]
Cisco 4700 Series Application Control Engine Appliance Administration Guide
6-28
Displaying Redundancy Configuration Information
Displaying Bulk Synchronization Command Failures on the Standby ACE
Displaying FT Group Information
Displaying the Redundancy Internal Software History
Displaying the IDMAP Table
Displaying Memory Statistics
Displaying Peer Information
Displaying FT Statistics
Displaying FT Tracking Information
Purpose
Displays the list of redundancy or fault-tolerance (FT) configurations configured
for the current context. The ACE also displays configuration information for each
ft configuration listed.
Purpose
Displays the commands that fail on the standby ACE appliance during bulk
synchronization in a redundant configuration per context. If all commands
succeed on the standby ACE appliance, the command displays the following
message:
No bulk config apply errors
In the Admin context, the optional context_name argument is the nameof a user
context. If you do not enter the argument, the command uses the Admin context.
In a user context, this argument is not available.
Chapter 6
Configuring Redundant ACEs
OL-20823-01