Shutting Down The Ace; Displaying Or Clearing The Ace Setup Configuration And Statistics; Displaying Ace Setup Configuration And Statistics; Displaying Ntp Statistics And Information - Cisco 4700M Administration Manual

Chapter 1 Setting Up the ACE
grub>

Shutting Down the ACE

This section describes how to remove power from the ACE by using the power button found on the front
panel.
Configuration changes that are not written to the Flash partition are lost after a shutdown. Before you
Caution
shut down the ACE, enter the copy running-conf startup-config command in Exec mode to store the
current configuration in Flash memory. If you fail to save your configuration changes, the ACE reverts to
its previous settings upon restart.
Detailed Steps
Command
Step 1
copy running-config startup-config
Example:
host1/Admin# copy running-config
startup-config
Press the front panel power button.
Step 2
Displaying or Clearing the ACE Setup Configuration and
Statistics
This section describes how to display or clear the ACE setup configuration and includes the following
topics:
•
•

Displaying ACE Setup Configuration and Statistics

This section describes how to display the ACE setup configuration and statistical information and
includes the following topics:
•
•

Displaying NTP Statistics and Information

This section describes how to instruct the ACE to display the following NTP statistics and information:
•
•
OL-20823-01
Displaying ACE Setup Configuration and Statistics
Clearing NTP Statistics
Displaying NTP Statistics and Information
Displaying Other ACE Setup Configuration Information
NTP peer statistics
Input/output statistics
Cisco 4700 Series Application Control Engine Appliance Administration Guide

Displaying or Clearing the ACE Setup Configuration and Statistics

Purpose
(Optional) Copies the running configuration to the startup
configuration.
Shuts down the ACE.
1-33