Using The Grub Boot Loader To Specify The System Boot Image During A Reload; Restarting The Ace; Restarting The Ace From The Cli - Cisco 4700M Administration Manual

Chapter 1 Setting Up the ACE
What to Do Next
You may now configure the ACE to define basic configuration settings for the appliance.

Restarting the ACE

You can reboot the ACE directly from its CLI and reload the configuration. When you reboot the ACE, it
performs a full power cycle of both the hardware and software. Any open connections with the ACE are
dropped. The reset process can take several minutes.
Configuration changes that are not written to the Flash partition are lost after a reload. Before rebooting,
Caution
enter the copy running-conf startup-config command in Exec mode to store the current configuration in
Flash memory. If you fail to save your configuration changes, the ACE reverts to its previous settings
upon restart.
This section includes the following topics:
•
•

Restarting the ACE From the CLI

This section describes how to reboot the ACE directly from its CLI.
OL-20823-01
[Linux-bzImage, setup=0x1400, size=0xb732b7a]
INIT: version 2.85 booting
Daughter Card Found. Continuing...
INIT: Entering runlevel: 3
Testing PCI path ....
This may take some time, Please wait ....
PCI test loop , count 0
PCI path is ready
Starting services...
Installing MySQL
groupadd: group nobody exists
useradd: user nobody exists
MySQL Installed
Installing JRE
JRE Installed
Starting sysmgr processes.. Please wait...Done!!!
switch login: admin
password# xxxxx
Restarting the ACE From the CLI

Using the GRUB Boot Loader to Specify the System Boot Image During a Reload

Cisco 4700 Series Application Control Engine Appliance Administration Guide
Setting Up the ACE
1-31