Chapter 6
Configuring Redundant ACEs
Table 6-6
Field Descriptions for the show ft track Command Output (continued)
Field
Description
State
State of the tracking process. Possible values are TRACK_UP or TRACK_DOWN.
Priority
Priority of the tracking process.
Transitions
Number of times that the active member of the FT group switched over to the standby member.
Probe Count
Number of probes associated with a TRACK_HOST process.
Probes Down
Number of failed probes.
Clearing Redundancy Statistics
To clear redundancy statistics, use the commands described in the following sections. You must enter all
commands in this section in the Admin context unless otherwise indicated.
This section contains the following topics:
•
•
•
•
•
Restrictions
If you configure redundancy on the ACE, then you must explicitly clear statistics on both the active and
the standby ACEs. Clearing statistics on the active appliance only does not clear the statistics on the
standby appliance.
Clearing Transport-Layer Statistics
To clear all transport layer-related counters that the ACE displays as part of the show ft peer detail
command output, perform the following task:
Command
clear ft ha-stats
OL-20823-01
Clearing Transport-Layer Statistics
Clearing Heartbeat Statistics
Clearing Tracking-Related Statistics
Clearing All Redundancy Statistics
Clearing the Redundancy History
Purpose
Clears all transport layer-related counters that the ACE displays as part of the show
ft peer detail command output.
This command clears the following transport-layer counters:
Tx Packets
•
Tx Bytes
•
Rx Packets
•
Rx Bytes
•
Rx Error Bytes
•
For an explanation of these fields, see the
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Displaying or Clearing Redundancy Information
"Displaying Peer Information"
section.
6-39