Displaying The Redundancy Internal Software History; Displaying The Idmap Table; Displaying Memory Statistics - Cisco 4700M Administration Manual

Displaying or Clearing Redundancy Information

Displaying the Redundancy Internal Software History

To display the redundancy internal software history, perform the following task:
Command
show ft history {cfg_cntlr | ha_dp_mgr |
ha_mgr}

Displaying the IDMAP Table

This section describes how to display the IDMAP table. The IDMAP table contains a list of the local
ACE to peer (standby) ACE ID mappings for each of the seven object types in the ACE. The local ID
and the peer ID for each object type may or may not be the same, but the mappings (local ID to peer ID)
should be the same on both the active ACE and the standby ACE. The ACE uses these mappings for
configuration synchronization and state replication.
To display the IDMAP table, perform the following task:
Command
show ft idmap
Table 6-3
Table 6-3
Object Type
0
1
2
3
4
5
6

Displaying Memory Statistics

To display redundancy statistics per context, perform the following task:
Cisco 4700 Series Application Control Engine Appliance Administration Guide
6-32
Purpose
Displays the redundancy internal software history.
The keywords are:
cfg_cntlr—Displays the configuration controller debug log
•
ha_dp_mgr—Displays the high availability (HA) dataplane manager
•
debug log
ha_mgr—Displays the HA manager debug log
•
Purpose
Displays the IDMAP table.
lists the IDMAP table object types available in the ACE.
ACE Object Types in the IDMAP Table
Object Name
REAL ID
RSERVER ID
SERVERFARM ID
POLICY ID
STICKY GROUP ID
IF ID
CONTEXT ID
Chapter 6 Configuring Redundant ACEs
OL-20823-01