Honeywell SV2 Series User Manual page 42

SV2 Series Safety Shut-off Valves
wiring is complete, the electrical connectors can them be plugged into their proper sockets and the Pressure Module (if used)
connector can be plugged into the socket labeled 'PRESSURE'.
F. Valve Modbus Bias Setup
The SV2 Series valve can communicate via Modbus RTU communication with any compatible device. Only RTU communications
with 1 start bit, 8 data bits, 1 stop bit and no parity is supported.
Refer to the SV2 Series Valves Installation Instructions (32-00018) and CHAPTER 3 : COMMUNICATION / CONNECTIVITY in
this manual for details on Modbus setup.
G. Install Plugs
Install the low and line voltage plugs in any unused wire entry locations for the NEMA 4 / IP66 valves to maintain the enclosure
rating.
42 32-00029—02