Honeywell SV2 Series User Manual page 130

SV2 Series Safety Shut-off Valves
Fig. 92: Reset Password dialog box with entered password.
7. When the Installer password has been successfully reset, the acknowledgement dialog box will appear. Refer to
Select OK to exit this mode.
Fig. 93: Password Reset acknowledgement dialog box.
8. After successful password reset back to the Installer default, the valve will be in lockout status. The user must login using
the applicable Honeywell default password level and assign a new Installer password. Refer to the Default Passwords
section and the Installer Password Configuration section of this manual for details.
OEM Password Reset Procedure
During initial valve commissioning, the OEM will be required to assign a main password and a reset password for the valve
(if enabled). These 2 passwords CANNOT be the same. However, the reset password CAN be the same for all individual OEM
valves/appliances.
If enabled, the reset password allows the OEM to reset the current OEM main password back to the Honeywell factory default
value. Typically, this would only be performed when the current OEM main password is lost. Once the password is reset, the
OEM can then log in and assign a new main password. The OEM assigned reset password remains unchanged, but the OEM
can choose to change it at any time on the Security page as desired by selecting the 'Change OEM Reset Password' button. Refer
to Fig. 70.
130
Fig. 93.
32-00029—02