Honeywell SV2 Series User Manual page 29

INSTALLATION QUICK START GUIDE
The SV2 Series valve installation steps are illustrated below in the Quick Start Guide.
NOTE: This section is an installation overview ONLY. Elaboration of each step is detailed in the SV2 Series Safety Shut-Off
Valves Installation Instructions, document 32-00018, which is shipped with each valve and available online.
What's in the box
A. Valve B. Accessory Box:
• Connectors (not EU)
• Cord grips (NEMA 4/IP66 versions only)
• Mounting Hardware (for C6097 Pressure Switch)
• Installation Instructions
• Premix pre-filter (V2V models)
1
Remove from box
2
Installation and Mounting
A. Orientation planning
B. Mounting flanges
C. Mount valve to
flanges and piping
• ¾, 1 inch
(DN20/25) valve
bodies have drilled
and tapped holes
• 1½ inch (DN40) and
larger valve bodies
with embedded slots
for flange retaining
nuts
SV2 Series Safety Shut-off Valves
V2F, V2V
SV2 SERIES SAFETY SHUT-OFF VALVES USER MANUAL
C. Accessories Ordered Separately:
• Flanges
• Pressure Module
• HMI or PC Tool
• Mixing unit
• Pulse lines
• Pulse line fittings
• Heat Exchanger
D. Vent valve connection
E. Premix mixing unit, pulse lines, air pre-filter and
outdoor air installations planning
F. Pressure Module or C6097 planning
• Investigate correct mounting location and pressure
access port
G. Mount Pressure Module or C6097
NOTE: The 1in/DN25 valve flange pressure port must
be installed facing sideways (refer to Figs. 2-3)
due to the mounting hole orientations.
NOTE: The 1.5-2.0 inch/DN40-50 valve flange
pressure port must be installed either facing
up or down (refer to Figs. 4-6) due to the
mounting hole orientations.
29