Honeywell SV2 Series User Manual page 31

5
Programming & Setup
Any intelligent features
requiring setup must be
completed before the valve
will be operational. The HMI
or PC Tools are used for this
purpose.
This includes:
• Valve modbus address +
communication speed
• Low gas pressure
• High gas pressure
• External VPS (using
Pressure Module)
• Fuel/air firing curve
(Premix/V2V models)
6
Wiring Checkout
A. Test:
• Cycle the valve several times to verify proper function.
• Each limit and interlock.
• Following burner management system checkout guidelines.
• Any other recommended or required tests.
7
Finish
A. Replace the electrical enclosure cover.
B. Replace solenoid cover (if removed).
C. Your valve is ready to use.
SV2 Series Safety Shut-off Valves
V2F, V2V
A. Connect Modbus wiring per HMI Tool or PC Tool Installation
Instructions.
B. Power SV2 Series valve and HMI or PC Tool.
C. Complete setup as required and run on-board test procedures as
required.
31
SV2 SERIES SAFETY SHUT-OFF VALVES USER MANUAL