Honeywell SV2 Series User Manual page 144

SV2 Series Safety Shut-off Valves
7. Select the required valve configuration groups. Refer to
a. If the 'Valve Security' group is checked, the OEM main password must be entered on this page. The OEM main password
provided must be the password that was entered when the selected configuration was created. Typically, this password
would be specific to a particular valve/appliance configuration and would be the same for valves/appliances of that
configuration from an OEM manufacturer in accordance with best practices. For further information on password
access levels and best practices, refer to
NOTE: The last entered and valid OEM main password is temporarily stored for the selected valve configuration. If the
same valve configuration is opened again, the OEM main password is automatically prefilled (refer to
different valve configuration is selected, the OEM main password must be entered again.
b. If the 'Valve Security' group is unchecked, the OEM main password does not need to be entered on this page. Refer to
Fig. 118.
Fig. 118: Valve Production Cloning configuration groups selection, with passwords, 'Valve Security' group not selected.
8.
Select the 'Load to Valve' button. As the user interface is sending the selected configuration to the valve, the progress bar
pops up to show download progress. Refer to
Fig. 119: Load valve configuration progress bar.
9. Once the data is successfully sent and verified, the text 'Data send successfully' is displayed at the top of the progress bar.
Refer to Fig. 120.
Table 24 and Fig.
CHAPTER 6.
Fig. 119.
144
117.
Fig. 117). If a
32-00029—02