Headset Battery Charger Wall Mount; Mounting The Srx2/Srx3 Battery Chargers - Honeywell A700 Hardware Reference Manual

Ring LED (Charge Status)
Solid Yellow
Blinking Red

Headset Battery Charger Wall Mount

This unit provides a convenient surface for mounting the headset battery charger and its
associated power supply on a wall.
Customer assembly required.
l
Customer assumes all responsibility for the installation of these units.
l
Avoid potential hazards (electrical wires, waterlines, and similar building components) when
l
drilling into the wall.
Avoid blocking power outlets and other wall receptacles when installing the charger.
l
Anchoring a wall mount to a wall stud generally results in a more stable installation. If you
l
drill into a wall stud, do not use a screw anchor in that hole.
Anchors must be at least 12 in. (30.48 cm.) from the floor to allow for proper attachment,
l
seating, and removal of the charger unit.

Mounting the SRX2/SRX3 Battery Chargers

You will need:
Drill
l
Fasteners
l
Screw driver
l
DIN rail, slotted steel 35 mm X 15 mm, Honeywell Part #CM-1000-20-101 or customer-
l
supplied DIN rail meeting the following specifications :
167
Alert LED (Battery Health)
Solid Red
Solid Red
Voice Device and Headset Hardware Reference Guide
Battery Status
Battery alert condition; charging
Battery alert condition; fault detected