Pairing-Related Configuration Parameters; Cross Pairing; Srx2/Srx3 Headset Pairing Methods; Srx3 Pairing Modes - Honeywell A700 Hardware Reference Manual

For example, if the user takes the headset out of range of the paired device or powers it off, the
device will notice the connection loss and try to reconnect. The two remain paired throughout
this process.

Pairing-related Configuration Parameters

PersistSrxPairingAcrossPowerCycle
Set to 0 for the device to delete the pairing when it is powered off.
When the device is powered on again, it will not reestablish this connection with the associated
headset.
This parameter defaults to 1, which causes pairings to be persisted and re-established when the
device is powered on.
When SrxAutoPairEnable is enabled (set to 1), PersistSrxPairingAcrossPowerCycle defaults to 0.
SrxClearPairingInCharger
Set to 1 to clear the pairing when the device is placed into a charger.
This parameter defaults to 0, or maintaining the pairing.
When SrxAutoPairEnable is enabled (set to 1), SrxClearPairingInCharger defaults to 1.
SrxAutoPairEnable
Set to 1 to turn on automatic pairing.

Cross Pairing

Cross pairing is the result of a master device pairing with a headset or other device that is not the
intended slave. If a user cannot isolate his or her device and headset from others and a cross
pairing occurs, the user should break the existing pairing and retry the intended pairing.
TIP
Prevent unwanted cross pairing by isolating the device and headset from all other Bluetooth
devices any time that the device is performing an inquiry scan to find the headset or pair
manually. Cross pairing is extremely unlikely when a user uses touch pairing.

SRX2/SRX3 Headset Pairing Methods

SRX3 Pairing Modes

After an SRX3 headset enters low or high power pairing mode, it is available to accept a pairing
initiated by a Talkman 700/ A700x or other Bluetooth-enabled device. These pairings can be
accomplished using a variety of methods.
Voice Device and Headset Hardware Reference Guide 124