Mounting The A700/A700X Battery Charger - Honeywell A700 Hardware Reference Manual

Part Number in Dia-
gram
5

Mounting the A700/A700x Battery Charger

You will need:
Drill
l
Fasteners
l
Screw driver
l
DIN rail, slotted steel 35 mm X 15 mm, Honeywell Part #CM-1000-20-101 or customer-
l
supplied DIN rail meeting the following specifications :
Number of Minimum
chargers on cut lengths
rail for rail
1 550 mm
2 1101 mm
3 1652 mm
1. Install the DIN rail on the wall in the desired location. Ensure that the secure installation,
supporting surface, and mounting hardware will safely support the weight of a fully loaded
charger, at 25 lbs. per linear foot (37.2 kg/m) of DIN rail. Ensure that the anchor holes are
at least 12 inches (30.5 cm.) from the floor. Verify that the installation meets all local
building codes.
IMPORTANT
The power supply for the charger should already be zip-tied in the back of the charger
chassis. If it is not, plug the power supply into the charger and secure it. Do not plug it
into a power source until after mounting is complete.
2. Before attaching the charger to the rail, open the locking arms on the back of the unit by
rotating the two levers out on each side of the charger. The arms are parallel to the floor in
the unlocked position.
163
Description
USB port for charger software upgrades (only on battery
charger)
DIN rail specs
Single unit length 550 mm; weight 331.5 g
(11.6933 oz)
Standard DIN rail
Voice Device and Headset Hardware Reference Guide