Msi Code - Honeywell A700 Hardware Reference Manual

Registry Key
Matrix2of5StartStop
Matrix2of5CodeMark
Matrix2of5BarCodeLengthL1
Matrix2of5BarCodeLengthL2
Matrix2of5BarCodeLengthL3
Matrix2of5BarCodeLengthMode
Matrix2of5UDSI

MSI Code

Support for the parameters in the table is labeled as follows:
ü = Parameter is supported and available via the Scanner Options tab in the device profile.
X = Parameter is not supported on this device.
NYI = Not Yet Implemented. These parameters should be considered unsupported, though
they can (with knowledge) be set via the CCI or advanced settings.
IMPORTANT
A730 and A730x support for symbologies and parameters may differ. Refer to the table
below for details.
The registry keys in the table below are located under:
[HKEY_LOCAL_MACHINE\Software\Vocollect\Imager\MSI Code]
Registry Key
MSIActivation
47
Default
A730
Value
0x0
ü
0x44
ü
0x6
ü
0x0
ü
0x0
ü
0x0
ü
B4
ü
Default
A730
Value
0x0
ü
Voice Device and Headset Hardware Reference Guide
A730x Description
Enables special ChinaPost mode,
X where a specific start/stop is required
and the checksum is transmitted.
A single character inserted before the
bar code data to indicate the
ü
symbology.
Length value L1. Range is 0x0 to 0xFF
ü
(0 to 255).
Length value L2. Range is 0x0 to 0xFF
ü
(0 to 255).
Length value L3. Range is 0x0 to 0xFF
ü
(0 to 255).
Length verification mode, where
0 = "L1 is min length",
1 = "L1, L2, L3 are fixed lengths" – Not
ü
supported on A730x,
2 = "L1 is min, L2 is max length".
User-defined symbology identifier.
ü
Range is 0-4 characters.
A730x Description
Enables the MSI Code (Modified
ü
Plessey) symbology.