Headset Battery Charger Wall Mount; Mounting The Srx2/Srx3 Battery Chargers - Honeywell SRX2 User Manual

allow the required space between wall mounted units and must avoid
stacking desktop units on top of each other.

Headset Battery Charger Wall Mount

This unit provides a convenient surface for mounting the headset battery
charger and its associated power supply on a wall.
Customer assembly required.
l
Customer assumes all responsibility for the installation of these units.
l
Avoid potential hazards (electrical wires, waterlines, and similar building
l
components) when drilling into the wall.
Avoid blocking power outlets and other wall receptacles when installing the
l
charger.
Anchoring a wall mount to a wall stud generally results in a more stable
l
installation. If you drill into a wall stud, do not use a screw anchor in that
hole.
Anchors must be at least 12 in. (30.48 cm.) from the floor to allow for proper
l
attachment, seating, and removal of the charger unit.

Mounting the SRX2/SRX3 battery chargers

You will need:
DIN rail, slotted steel 35 mm X 15 mm, Honeywell Part #CM-1000-20-101
l
or customer-supplied DIN rail meeting the following specifications
Number of
chargers on rail
Drill
l
Fasteners
l
55
Minimum cut lengths
for rail
550
1
mm
1101
2
mm
1652
3
mm
Standard
DIN rail specs
DIN rail
Single unit length
550 mm; weight
331.5 g (11.6933
oz)
SRX3 User Guide - Preliminary