Unpairing The 8680I - Honeywell A700 Hardware Reference Manual

The 8680i must be set to Host Reconnect Mode (the device will attempt to connect to the
l
device host, and if disconnected the device will manage the reconnection).
The 8680i must be configured to add termination characters (i.e., <CR><LF>).
l
The 8680i User Guide contains bar codes to set other combinations of termination
l
characters.
NOTE
The first three steps below only need configured once for each 8680i. If the 8680i is already
configured, start with step 4.
1. Restore factory defaults by scanning the Remove Custom Defaults and Activate Defaults bar
codes.
2. Scan the Host Reconnect Mode bar code.
3. Scan the bar code to add a carriage return and line feed as termination characters.
4. Set the BluetoothScannerConnectionMenuEnable parameter to "1".
5. Select the menu option Touch pair Bluetooth scanner by pressing the device- button three
times.
This menu option is not available if a scanner is already connected.
l
The device NFC reader is activated.
l
The device device state (ring) indicator blinks green.
l
The operation can be cancelled by pressing the Play/Pause button, connecting or
l
disconnecting a headset, or placing the device in a charger.
6. The device speaks "Please touch pair a scanner or press play/pause to cancel".
7. Place the 8680i next to the device.
The 8680i should be flush against the side of the device, centered on the A700x NFC
l
target (indicated by the
the device (this is the end of the device which is inserted into a charger).
Ensure the 8680i is awake by pressing the Scan button. A buzz sound will be heard
l
when the 8680i is not connected.
8. When the tag is read, the device speaks "Scanner detected, please wait".
The device ring LED is spinning yellow.
l
The device buttons are disabled while pairing.
l
The 8680i will beep to indicated it is connected.
l
The device ring LED will start blinking green.
l
The NFC reader will shut off.
l
9. The device will speak "Scanner paired" and then "Goodnight".

Unpairing the 8680i

Use this process to disconnect an 8680i that was TouchConnect paired with an device.
Voice Device and Headset Hardware Reference Guide
icon). The 8680i should be pointed toward the bottom of
172