Fasten The Ground Wire; Attach The A700/A700X Vmt To The Vehicle - Honeywell A700 Hardware Reference Manual

1. Remove the nuts and bolts from the positive battery terminal.
NOTE
When you remove the battery terminal side post bolts from the vehicle battery, the
vehicle computer and radio return to their default settings.
2. Fasten a 3/8-inch nut to the 3/8 x 1-1/2-inch positive battery terminal post.
3. Place a 3/8-inch washer on the battery terminal post.
4. Slide the positive wire fuse link terminal ring from the power input cable onto the positive
battery post.
5. Put another 3/8-inch washer on the battery terminal post.
6. Slide the positive battery cable on the post.
7. Insert the post assembly (Steps 2 through 6) into the positive battery terminal.
8. Tighten the battery terminal post securely.
9. Tighten the nut installed in Step 2 to secure the washers and cables firmly in place.
10. Repeat Steps 1 through 9 for the negative wire.
11. Connect the ground wire. See "Fasten the Ground Wire".

Fasten the Ground Wire

1. The braided wire on the vehicle battery cable is the grounding strap. To ensure proper cable
shielding, fasten the ground strap to the vehicle sheet metal.
2. Drill a small hole into the metal that you intend to fasten the ground wire to.
3. Use a punch to dimple and enlarge the hole until it is the same size as the screw.
4. Scrape off a small circle of paint around the hole to make sure bare metal is exposed.
5. Secure the wire with a #8 5/8-inch screw and flat washer.

Attach the A700/A700x VMT to the Vehicle

Voice Device and Headset Hardware Reference Guide 92