Charging An A700/A700X Battery In A Charger; Inserting A Battery Into A Talkman A700/A700X Device - Honeywell A700 Hardware Reference Manual

Charging an A700/A700x Battery in a Charger

NOTE
A battery is fully charged and can be removed from the charger when the ring LED
l
indicator light for that port on the charger is green.
If you insert a fully charged battery into a charger, the charger will analyze the battery's
l
status and indicate charge status immediately.
1. Make sure the battery charger is powered. To power on the charger, connect the power
supply to the charger and a power source. The LED indicator light at the bottom right of
the charger face panel should be solid green.
2. Power off the device.
3. Remove the battery from the
4. Hold the battery with the pins downward and facing away from you, and push it onto an
empty port on the battery charger until it snaps into place.
5. The ring LED lights yellow to indicate the battery is charging.
6. When the ring LED indicator turns a solid green, the battery is fully charged. Pull the battery
off the charger port to insert it into the device.

Inserting a Battery into a Talkman A700/A700x Device

Make sure the battery to be inserted is fully charged.
Voice Device and Headset Hardware Reference Guide
device.
14