Error Message
"Unable to retrieve operator files."
"Unable to send output data."
"Unable to train words. Not enough free flash memory."
"Warning, low flash memory!"
"Warning, low flash memory! You must upload your
collected data now!"
Troubleshooting Peripheral Problems
Troubleshooting Display Devices
If the display does not pair or appear to work:
1. Be sure that the display is on, Talkman is on, and the display battery and Talkman battery
are both charged.
2. Verify that both display and Talkman are connected to the same wireless network. Verify
that Talkman is running a VoiceApplication which supports displays.
3. Verify that display is pointing to the right web address and Talkman device.
Troubleshooting Bluetooth Scanners
With any relatively open communication system like Bluetooth, parameters must be set correctly
for successful data transmission. The following sections include common settings and problem
areas for Bluetooth scanners.
The Scanner will not Scan
These steps apply to bar code scanners external to the Talkman device and not the integrated
scanner in the Talkman A730/A730x.
1. Make sure the scanner is on, plugged into the Talkman device properly, and that the battery
is charged.
269
Solution
1. Turn the device off and then turn it back on again.
2. Reboot the device.
3. Reload VoiceClient.
1. Turn the device off and then turn it back on again.
2. Reboot the device.
3. Reload VoiceClient.
1. Wait for the device to go to sleep.
2. Turn the device off and then turn it back on again.
3. Reboot the device.
4. Reload VoiceClient.
1. Go to an area of known good coverage.
2. Turn the device off and then turn it back on again.
3. Reboot the device.
4. Reload VoiceClient.
5. Place the device in a charger as soon as possible.
1. Go to an area of known good coverage.
2. Turn the device off and then turn it back on again.
3. Reboot the device.
4. Reload VoiceClient.
5. Place the device in a charger as soon as possible.
Voice Device and Headset Hardware Reference Guide