Honeywell A700 Hardware Reference Manual page 190

Number of Minimum
chargers on cut lengths
rail for rail
1 550 mm
2 1101 mm
3 1652 mm
1. Install the DIN rail on the wall in the desired location. Ensure that the secure installation,
supporting surface, and mounting hardware will safely support the weight of a fully loaded
charger, at 25 lbs. per linear foot (37.2 kg/m) of DIN rail. Ensure that the anchor holes are
at least 12 inches (30.5 cm.) from the floor. Verify that the installation meets all local
building codes.
IMPORTANT
The power supply for the charger should already be zip-tied in the back of the charger
chassis. If it is not, plug the power supply into the charger and secure it. Do not plug it
into a power source until after mounting is complete.
2. Before attaching the charger to the rail, open the locking arms on the back of the unit by
rotating the two levers out on each side of the charger. The arms are parallel to the floor in
the unlocked position.
3. Attach the charger to the DIN rail by hanging the two hooks on the back of the unit on the
top lip of the rail.
4. Slide the charger horizontally to the desired position on the rail, and rotate the locking
arms into the locked position - flush with both sides of the unit.
5. If the charger does not feel secure on the rail, adjust the rubber stops on the back of the
unit by screwing them out toward the wall.
6. Plug the power supply into a power source and check the LED indicator at the bottom right
of the charger face. If the indicator light is a solid green, the charger is powered on.
Voice Device and Headset Hardware Reference Guide
DIN rail specs
Single unit length 550 mm; weight 331.5 g
(11.6933 oz)
Standard DIN rail
168