Attaching The Sr-15 Headset Adjustment Strap; Replacing The Headband Cord Clip On The Sr-15 Headset - Honeywell A700 Hardware Reference Manual

4. Repeat these steps for the clip on the other side.

Attaching the SR-15 Headset Adjustment Strap

1. Align the keying rib on the plunger with the slot in the barrel.
2. Push the plunger all the way down until the plunger top lip contacts the top of the barrel,
making sure the keying rib is inside the keying rib slot.
3. With the plunger pressed all the way in, place the headband into the slot on the side of the
adjustment strap barrel.
4. Repeat these steps for the clip on the other side.

Replacing the Headband Cord Clip on the SR-15 Headset

1. Unclip the cord from the headband cord clip by pushing the plunger all the way down and
gently pulling the cord out of the clip.
2. Remove the two screws (part 3 in the figure below). Screws require a Phillips #1 driver.
Note that older headband parts may require a Torx or Allen driver.
3. Place the headband in the groove of the replacement clip assembly part 2. Place clip
assembly part 1 over the headband, aligning with the groove and screw holes on part 2.
145 Voice Device and Headset Hardware Reference Guide